|
Language: EN | BM |
Centralised Systems with Screw Oilless Variable Speed System

Share:


Centralised Systems with Screw Oilless Variable Speed System

Quantity: In Stock



Becker provides intelligent pneumatic solutions for one or several production machines.

In central pneumatic systems, multiple single pumps on separate production machines are replaced by just a few larger vacuum pumps and/or compressors in a separate room (control room, basement etc.). The units are connected to the production machines via pipes.

Central pneumatic systems provide your machines with on-demand vacuum and blast air, which means energy savings. Noise levels are drastically reduced in employee work areas.

Each pneumatic supply in a centralised system is equipped with its own frequency converter. Thus, the pneumatic requirements of each production machine can be continuously adapted for any given operating point. By average, frequency-controlled units operate at a relative speed of approx. 65%. Overall, this leads to significant energy savings over separate units and devices without speed controlling.

Our central pneumatic systems are always optimised for your specific requirements. Each system is designed and configured especially for the requirements of the given application.

Advantages:

No heat or noise emission in production area
In production facilities, workplaces are being subjected to ever more stringent noise and heat emission regulations. In centralised pneumatic systems, there is no longer a need for separate vacuum pumps and compressors. Employees are subjected to minimum levels of heat, noise and oil mist.

Lower energy requirements for air conditioning systems
Eliminating the many separate pumps leads to a significant reduction in convection heat. Thus, air conditioning systems are subjected to lower loads and consume less energy. By removing the exhaust outlets (and the accompanying oil mist) from the production area, the air quality is greatly improved in the production area.

Energy savings using VACON controller
The central systems are controlled using the VACON controller. The VACON controller monitors and controls up to 4 different pressure or vacuum levels.

Central maintenance area
In centralised pneumatic systems, you can inspect and service the pneumatic supplies at a single location. It is much easier to access and inspect these units than to having to travel to each single supply unit for this purpose.


Lower maintenance requirements
Plants without a centralised pneumatic supply system typically have multiple vacuum pumps and compressors from multiple manufacturers in production. The many different replacement and wear parts required for each separate system results in drastically increased logistics and becomes expensive for the plant operator. Generally speaking, vacuum pumps and compressors in centralised pneumatic systems are low maintenance and utilise many of the same parts and materials. This restricts the range of required parts to an absolute minimum.

 Inquiry - Centralised Systems with Screw Oilless Variable Speed System